@article { author = {Hoseini, S and Esmaeili Varaki, M and Fazleola, R}, title = {Experimental Investigation of Scour around Inclined Bridge Piers Group Based on Piles Group}, journal = {Water and Soil Science}, volume = {26}, number = {4.2}, pages = {135-147}, year = {2017}, publisher = {University of Tabriz}, issn = {2008-5133}, eissn = {2717-3755}, doi = {}, abstract = {In this research, the effects of pile cap thickness and its top level of installation, arrangement and diameter of piles on variation of local scour around the inclined bridge piers group were investigated experimentally. A Physical model of piers group having two inclined rectangular piers with 28 degrees inclination angle was constructed on a pile cap. Experiments were performed on piles group with relative diameters ( ) of 0.6 and 0.9, piles arrangement of 2×2 and 2×3, relative pile cap thicknesses ( ) of 0.9 and 1.4 and the pile cap relative installation levels ( ) of 1.5, 1, 0.5, 0 and also its buried condition at the level of -0.7 and -1.2. Comparison of the maximum scour depth indicated that the change of pile arrangement from 2×2 to 2×3 caused 50 and 60 percent increases in the scour depth related to the ratio of  with the amount of 0.6 ad 0.9, respectively. However, changes of the pile diameter and arrangement did not have any effect on the maximum scour depth as pile cap installed in the same level of bed or lower than it i.e. in buried condition. Comparison of the results showed that changes of the pile cap thickness from 0.9 to 1.4 times the pier width, caused the maximum scour depth for all pile geometry and top level installation of the pile cap to be increased 20 percent approximately. Furthermore, as pile diameter increased from 0.6 to 0.9 bridge pier width, the maximum scour depth for installation of the pile cap above the bed increased 5 and 10 percent approximately for pile arrangement of 2×2 and 2×3, respectively.}, keywords = {Bridge,Inclined bridge piers group,Level of pile cap,Piles group,Scour}, title_fa = {مطالعه آزمایشگاهی آبشستگی اطراف گروه پایه کج مستقر بر گروه شمع}, abstract_fa = {در تحقیق حاضر تغییرات عمق آبشستگی اطراف گروه پایه کج مستقر بر گروه شمع در شرایط مختلف تراز کارگذاری و ضخامت سرشمع، آرایش و قطر شمع‌ها، به‌صورت آزمایشگاهی بررسی شد. گروه پایه‌ مورد بررسی متشکل از دو پایه کج مستطیلی بود که با زاویه 28 درجه بر روی سر شمع نصب گردید. آزمایش­ها روی گروه شمع­ها با قطر­های نسبی (نسبت قطر شمع به قطر پایه ) 6/0 و 9/0، در آرایش 2×2 و 3×2 و برای دو ضخامت نسبی سر شمع ( )، 9/0 و 4/1 و نیز ترازهای نسبی مختلف کارگذاری سر شمع ( )، 5/1، 1، 5/0، صفر و در حالت مدفون 7/0- و 2/1- انجام شد. مقایسه نتایج بیشینه عمق آبشستگی نشان داد که با تغییر آرایش شمع‌ها از 2×2 به 3×2 به‌طور متوسط مقدار بیشینه عمق آبشستگی در قطرهای نسبی شمع 6/0 و 9/0 به‌ترتیب 50 و 60 درصد افزایش می‌یابد. در شرایط کارگذاری سرشمع‌ها هم‌تراز بستر و مدفون، تغییر آرایش و قطر شمع‌ها، تأثیر محسوسی بر بیشینه عمق آبشستگی نداشت. بررسی نتایج مربوط به ضخامت سرشمع حاکی از آن‌است‌که برای ترازهای نسبی کارگذاری سر شمع بالای بستر، با افزایش ضخامت نسبی سرشمع از 9/0 به 4/1، مقدار بیشینه عمق آبشستگی برای هندسه و قطرهای مختلف شمع، به‌طور متوسط 20 درصد افزایش می‌یابد. هم‌چنین با افزایش قطر شمع‌ها از 6/0 به 9/0 در ترازهای نسبی کارگذاری سرشمع بالای بستر، مقدار بیشینه عمق آبشستگی در آرایش‌های شمع 2×2 و 3×2، به‌طور متوسط 5 و 10 درصد افزایش یافت.}, keywords_fa = {آبشستگی,تراز سرشمع,گروه پایه کج,گروه شمع‌ها,پل}, url = {https://water-soil.tabrizu.ac.ir/article_5892.html}, eprint = {https://water-soil.tabrizu.ac.ir/article_5892_f660fde6edc0fe7d663dea6dfa65f8bc.pdf} }